Page 1 of 1

fj key program

Posted: Tue Feb 15, 2011 12:29 am
by admin

Begin With;
- Driver's door open and unlocked
- Key out of ignition
1. Insert and remove the key from the ignition switch 2 times within 5 seconds

NOTE: Steps 2 and 3 should be performed within 40 seconds

2. Close and open the driver's door TWICE.

3. Insert the key into the ignition and remove it.

NOTE: Steps 4-6 should be performed within 40 seconds

4. Close and open the driver's door TWICE

5. Insert the key into the ingnition

6. Close the door

7. Turn the ignition switch from "LOCK" to "ON" and back to "LOCK" at about 1 second intervals to select the desired mode from the list below:
- 1 time for ADD mode
- 2 times for REWRITE mode
- 3 times for CONFIRMATION mode
- 5 times for PROHIBITION mode

8. Remove the key from the ignition

9. To confirm your mode selection, the power locks will now cycle "lock" to "unlock" a number of times corresponding to your key cycles in step 7.

NOTE: If CONFIRMATION or PROHIBITION modes have been selected, opening the door will complete the procedure.

10. For ADD or REWRITE modes, do the following within 40 seconds of Door Lock confirmation;
A - Press both transmitter LOCK and UNLOCK buttons simulataneously between 1 and 1.5 seconds and release. (I had to do this a few times because I held the buttons down longer than the 1-1.5 seconds)
B - Within 3 seconds of step A, press the transmitter LOCK button from more than 1 second and release.
> If the transmitter has been successfully programmed, the power locks will cycle "lock" to "unlock" once at this time.
> If there are problems with the transmitter or the procedure up to this point, the locks will cycle twice. If this occurs, verify that you have received the correct transmitter, and then repeat the above procedure.
C - If multiple remotes are to be reprgrammed, repeat steps A and B

11. Open to driver's door to conclude programming mode

12. If you make an error during the programming mode, turn the ignition key to "ON" and back to "LOCK" to erase entered steps.

Good luck and ping me if you have any questions or issues. This procedure works for all 2007 and 2008 FJs as well as the following;

2000 - 2005 Celica
2001 - 2003 Prius
2001 - 2005 ECHO
2001 - 2007 Highlander
2001 - 2008 RAV4
2002 - 2006 Camry
2003 - 2008 Avalon, Corolla and Matrix
2004 - 2008 Sienna and Solara
2005 - 2008 Tacoma
2007 - 2008 FJ Cruiser and Yaris

Posted: Tue Feb 15, 2011 1:56 pm
by Wasif Ahmed
What is this proceedure for ??? Can't understand

Posted: Tue Feb 15, 2011 2:55 pm
by admin
[quote=Wasif Ahmed;2021]What is this proceedure for ??? Can't understand[/quote]

this is if you need 2 program new key 4 fj